Tank Water Heater Installation in Kissimmee, FL

If your job requires a permit (most do in Florida under current code), we'll handle every detail. We'll submit the permit application with our contact information, schedule the work for your preferred window, and confirm delivery of your new unit from our supplier.

We'll coordinate access to your utility connections (gas shutoff, water main, electrical panel) and send you a written pre-installation confirmation so you're ready for the day we arrive. If inspections are required in your jurisdiction, we'll schedule the inspector and ensure all requirements are met before work begins.

On installation day, our crew arrives with all necessary tools and equipment. We safely drain your old water heater by running the drain line to a floor drain or bucket. We disconnect gas (if applicable, shutting off the main valve at the regulator), electrical connections, and water supply lines using proper shutoff valves.

We remove the old unit carefully and dispose of it responsibly through an approved recycling program. We then prepare the installation area — leveling the floor pad, removing any corrosion or sediment, ensuring clearance for the new tank, and setting up proper venting pathway and access space for future maintenance.

Your new tank connects to the incoming cold water line, outgoing hot water distribution line, and either a gas line or electrical power supply. We install a temperature and pressure relief valve (a critical safety component), sediment trap, and gas or electric heating components exactly to manufacturer specifications.

We use flexible connectors where appropriate and ensure all connections are secure. We run preliminary pressure tests for leaks using compressed air, then charge the system with water and retest. For gas units, we verify proper burner ignition and flame color. For electric units, we confirm heating element function and thermostat activation.

Once everything is connected and pressurized, we run the system through a complete heating cycle to verify hot water reaches your fixtures and the tank heats to your set temperature. We walk you through the controls — how to adjust the thermostat safely (we typically set it to 120°F for energy efficiency and safety), where the shutoff valves are located, how the relief valve works, and what the digital display (if present) is telling you.

We explain basic maintenance: annual flushing to remove sediment buildup (especially important in Florida's hard water), checking the relief valve annually, and watching for signs of corrosion. We'll give you the full documentation — warranty card, user manual, permit approval, and a photo record of the installation — and answer any questions before we leave.